I built a 10-inch ePaper dashboard for my 3D printer, and it's the best display I've ever used
This title could be clearer and more informative.Try out Clickbait Shieldfor free (5 uses left this month).
A hands-on review and build log of the Seeed reTerminal E1003, a 10.3-inch monochrome ePaper display powered by an ESP32-S3. The author built a 3D printer monitoring dashboard using ESPHome, detailing the hardware specs (1872x1404 resolution, 16 grayscale levels, 32MB flash, 8MB PSRAM, temperature/humidity sensor, buzzer, microphone), the process of reverse-engineering the GT911 touchscreen controller from firmware binaries, and the current lack of native ESPHome support. Despite the setup friction, the result is praised as a premium, low-distraction Home Assistant dashboard. TRMNL is mentioned as a plug-and-play alternative.
Table of contents
Ten inches of e-paper looks better than any LCD I've put on my deskESPHome support isn't there yet, so I rolled my ownIt's not plug-and-play, but that's comingSort: